Hitachi 55HZT66U Instruction Manual page 19

Configuring Wired Network Settings in
Advanced Mode
After pressing the GREEN button, the "Advanced
mode" will be available. While in Advanced Mode,
press the RED button to edit settings. When finished,
press OK to save, Press RETURN/BACK to cancel.
Wireless Connectivity
To Connect to a Wireless Network
• You must have a modem/router connected to an
active broadband connection.
• To configure your wireless settings please refer
to the Network settings section in this manual.
• A Wireless-N router (IEEE 802.11a/b/g/n) with
simultaneous 2.4 and 5 GHz bands is designed
to increase bandwidth. These are optimized for
smoother and faster HD video streaming, file
transfers and wireless gaming.
• Use a LAN connection for quicker file sharing
between other devices like computers.
• The frequency and channel differ depending on the area.
• The transmission speed differs depending on the
distance and number of obstructions between the
transmission products, the configuration of these
products, the radio wave conditions, the line traffic
and the products that you use. The transmission may
also be cut off or may get disconnected depending
on the radio wave conditions, DECT phones or any
other WiFi 11b appliances. The standard values of
the transmission speed are the theoretical maximum
values for the wireless standards. They are not the
actual speeds of data transmission.
• The location where the transmission is most effective
differs depending on the usage environment.
• The Wireless LAN adaptor supports 802.11 a,b,g &
n type modems. It is highly recommended that you
should use the IEEE 802.11n communication protocol
in order to avoid any possible problems while watching
videos.
• You must change your modem's SSID when there are
any other modems around with the same SSID. You
can encounter connection problems otherwise. Use
a wired connection if you experience problems with a
wireless connection.
For any help concerning set up and use of your TV please call the Customer Helpline:
Broadband
ISP
connection
Wireless LAN
adaptor
USB inputs
on the rear
side of the TV
English - 18 -
Configuring Wireless Device Settings
To enable Wi-Fi features, open the Network Settings
menu and select Network Type as Wireless Device
to start connection process.
Press the YELLOW button to scan the wireless
networks. A list of available networks will be displayed.
Please select your desired network from the list.
Note: If the modem supports N mode, you should set
N mode settings.
If the selected network is protected with a password,
please enter the correct key by using the virtual
keyboard. You can use this keyboard via the navigation
buttons and the OK button on the remote control.
Wait until the IP address is shown on the screen.
This means that the connection is now established. To
disconnect from a wireless network highlight "Network
Type" and press OK.
You can navigate between menu tabs by pressing left/
right buttons. The help bar on the bottom of the dialog
shows features that you may use. Press the BLUE
button to check your internet connection speed. Press
the GREEN button to switch to advanced mode and
then press the OK button to edit settings.
You can check the signal strenght by using the network
settings menu for the wireless device mode.
Other Information
Configuration Status: Displays Wi-Fi status as
connected or not connected.
IP Address: Displays the current IP address.
Network Name: Connected networks' name will be
displayed.
Delete Saved Wi-Fi Profiles
Saved profiles will be deleted if you press the RED button
while the wireless device selection OSD is on the screen.
Connecting to your mobile device via WiFi
• If your mobile device has WiFi feature, you can connect
it to your TV via a router, in order to access the content
in your device. For this, your mobile device must have
an appropriate sharing software.
• Connect to your router following the steps stated above
in the "Wireless Connectivity" section.
• Afterwards, engage your mobile device with the router
and then activate the sharing software on your mobile
device. Then, select files that you want to share with
your TV.
• If the connection is established correctly, you will be
able to access the shared files from your mobile device
via the Media Browser of your TV.
• Enter the Media Browser menu and the playback
device selection OSD will be displayed. Select your
mobile device and press the OK button to continue.
0345 604 0105