GE Moisture monitor series 3 Programming Manual page 33

Setting Up Recorders
(cont.)
Advanced Programming
Table 3-2: Measurement Modes
Display Abbreviation
O
H
T
P
Aux 1
Aux 2
User*
Vref
Gnd
*User functions are available only through PanaView
software (see Programming User Functions in Chapter 4).
Select Units
[DP/°C] DP/°F
Note: The number of measurement choices and the units of
measurement vary depending on the measurement mode
selected.
Set RCD-A OUTPUT
[ZERO] SPAN
RCD-A Zero Setup
20.0
Repeat the two final steps to enter the span value.
You may now do one of the following:
•
Set up another recorder by pressing
Select Recorder step, and then begin with the recorder selection
step (refer to Figure 3-2 on page 3-48 and Figure 3-3 on page 3-49
for a menu map of the user program).
•
Refer to another section and perform a different procedure. Refer
to Figure 3-2 on page 3-48 and Figure 3-3 on page 3-49 to navigate
through the user program.
•
[RUN]
Exit by pressing the
Measurement Mode
Oxygen
Hygrometry
Temperature
Pressure
Auxiliary 1
Auxiliary 2
User Function
Volt Reference
Signal Ground
1 Use arrow keys to move the
brackets to the desired units and
[YES]
press .
1
Use the arrow keys to move the
brackets to ZERO and press
[YES]
.
1
Enter the zero value and press
[YES]
. Then press
return to the previous screen.
[NO]
until you return to the
key.
March 2008
[NO]
to
3-5