Network - D-Link DIR-879 User Manual

Section 4 - Configuration - Extender Mode
This section will allow you to change the local network settings of the
extender and to configure the device's connection to the uplink network. In
the Settings menu on the bar on the top of the page, click Network. Click
Advanced Settings... to expand the list and see all of the options.
Network Settings
Management The default address to access the extender's configuration is
http://dlinkrouter.local./ Here, you can replace dlinkrouter with a
Link:
name of your choice.
Advanced Settings - IPv4 Device Management Interface
My LAN Choose the IPv4 provisioning mechanism used by the extender. Select
Connection Is:
either Dynamic IP (DHCP) or Static IP. The Default is Dynamic IP.
If you change the connection type to Static IP, configure the following options:
IP Address: Enter the IP address of the extender. If you change the IP address,
once you click Save, you will need to enter the new IP address in your
browser to get back into the configuration utility
Subnet Mask: Enter the subnet mask of the extender. The default subnet mask is
255.255.255.0.
Gateway Address: Enter the IP address of the device the Extender connects to.
Primary DNS Enter the primary DNS server IP address assigned by your ISP. If you
Server:
do not know it, enter the Gateway Address.
Secondary DNS
Enter the secondary DNS server IP address assigned by your ISP. If
Server: you do not know it, enter the Gateway Address.
Click Save when you are done.
D-Link DIR-879 User Manual

Network

104