Toro Greensmaster 3150 Service Manual page 105

Removal (Fig. 47)
1. Before removing any parts from the hydraulic sys-
tem, park machine on a level surface, set brake, lower
cutting units, and stop engine.
CAUTION
Before continuing further, read and become fa-
miliar with General Precautions for Removing
and Installing Hydraulic System Components.
2. Label all hose connections for reassembly pur-
poses
3. Remove hose assemblies and O–rings from hy-
draulic fittings at the cylinder. Allow hoses to drain into
a suitable container.
4. Remove lock nut and flat washer from barrel mount-
ing stud. Remove steering cylinder from barrel stud.
5. Remove cotter pin, slotted hex nut and and spacer
from rod end at rear wheel castor fork.
6. Remove steering cylinder from traction unit.
Greensmaster 3150
Installation (Fig. 47)
1. Secure cylinder rod end to the castor fork with
spacer, slotted hex nut, and cotter pin to rear wheel cas-
tor fork.
2. Install hydraulic fittings and O–rings to the steering
cylinder.
3. Install steering cylinder over barrel mounting stud
and secure with flat washer and lock nut.
4. Connect hydraulic hoses and O–rings to the hy-
draulic fittings. Tighten hose connections.
Page 4 – 81 Rev. C
Hydraulic System