D-Link AC3200 Ultra User Manual page 32

Section 3 - Installation - Access Point
The Home Page will open, click the Settings menu and Select Internet.
Select AP Mode from Device Mode and click Save. Allow 1 minute for the
DIR-890L to reboot into Access Point mode.
D-Link DIR-890L User Manual
Hardware Setup (continued)
Home Settings
DIR-890L HW:A1 FW:1.10
Internet Connected
Click on any item in the diagram for more information.
Internet DIR-890L
Internet
Cable Status: Connected MAC Address:
Connection Type: Dynamic IP (DHCP) IP Address:
Network Status: Connected Subnet Mask:
Home Settings
Connection Uptime: 1 Day 3 Hour 50 Min 58 Sec Default Gateway:
DIR-890L HW:A1 FW:1.10
Primary DNS Server:
Release IP Address
Secondary DNS Server:
Internet
Use this section to configure your Internet Connection type. There are several connection types to choose
from Static IP, DHCP, PPPoE, PPTP, L2TP and DS-Lite. If you are unsure of your connection method,
please contact your Internet service provider. Note: If using the PPPoE option, you will need to remove or
COPYRIGHT © 2016 D-Link
disable any PPPoE client software on your computers.
Settings >> Internet
Device Mode: Router Mode
Router Mode
AP Mode
My Internet Connection is: Static IP
Dynamic IP (DHCP)
PPPoE
PPTP
L2TP
DS-Lite
COPYRIGHT © 2016 D-Link
60 Sec
Rebooting
Features Management
Connected Clients: 1
USB Device
IPv4 / IPv6
FF:FF:FF:FF:FF:FF
172.17.5.120
255.255.255.0
Features Management
172.17.5.1
172.17.5.5
172.17.5.6
Go to settings
Save
IPv6
Advanced Settings ...
27