Canon ImageRUNNER 2545i Sending And Facsimile Manual page 284

Search condition includes characters that cannot be used with the selected server.
Cause 1 "\" is used in the search criterion.
Remedy Remove "\" from the search criterion, and then search again.
Cause 2 The combination of characters used in the search criterion does not constitute
an acceptable search criterion.
• There is an unequal number of "(" and ")".
• "*" is not placed within "( )".
Remedy Make sure that the characters for the search criterion are combined properly,
and then search again.
Cause 3 If <Server LDAP version and character code> is set to 'Ver.2 (JIS)', characters
other than ASCII Code (0x20-0x7E) are being used.
Remedy Omit characters that cannot be used, and then search again.
Set the IP Address.
Cause No IP address has been set for the machine.
Remedy Specify the IP address, and then turn the machine's main power OFF and back
ON again. (See Chapter 2, "Connecting the Machine to a TCP/IP Network," in
the System Settings Guide.)
SSL Error (POP)
Cause 1 POP authentication failed and a transmission error occurred due to
SSL-encrypted communication error when using POP before SMTP.
Remedy 1 Check the settings for SSL-encrypted communications on the POP server.
Remedy 2 Disable SSL-encryption for communications with the POP server by setting
<Allow SSL (POP)> in the E-mail/I-Fax setting to 'Off'. (See Chapter 3, "Setting
up the Machine for Your Network Environment," in the System Settings Guide.)
Remedy 3 Disable POP before SMTP by setting <POP Authentication before Send> in the
E-mail/I-Fax setting to 'Off'. (See Chapter 3, "Setting up the Machine for Your
Network Environment," in the System Settings Guide.)
Cause 2 POP authentication failed and a reception error occurred due to an
SSL-encrypted communication error.
Remedy 1 Check the settings for SSL-encrypted communications on the POP server.
Self-diagnostic Display
9
9-9