Greasing The Machine; Replacing The Warning; Decal; Reading The Manuals And Viewing The Dvd - Toro 30410 Operator's Manual

1. Mount the manual tube to the seat suspension
with the 2 R-clamps included in loose parts.
2. Install the seat belt to each side of the seat with
a bolt and lock washer, supplied in loose parts.
Important: Make sure that the seat
switch wire is connected to the seat switch
connector on the harness.
3. Slide the seat completely forward and backward
to ensure proper operation and that seat switch
wires and connectors are not pinched or do no
contact any moving parts.
Step
2

Greasing the Machine

No Parts Required
Procedure
Before the machine is operated, it must be greased
to ensure proper lubricating characteristics; refer
to Greasing the Bearings and Bushings procedure
of Lubrication, page 34. Failure to properly grease
the machine will result in premature failure of
critical parts.
Step
3

Replacing the Warning

Decal

Parts needed for this step:
1 Warning Decal
Procedure
1. On machines used outside of the U.S.A.,
replace the warning decal, part no. 112–9118
with the warning decal part no. 106–6752.
Step
4
Reading the Manuals and
Viewing the DVD
Parts needed for this step:
1 Operator's Manual
1
Engine Operator's Manual
1 Parts Catalog
1 Operator Training DVD
1
Pre-delivery Inspection Sheet
1 CE certicate
Procedure
1. Read the manuals.
2. View the Operator Training DVD.
15