Glow Plug Indicator Light
When lit, the glow plug indicator light (Fig. 24) indicates
that the glow plugs are on.
Engine Temperature Gauge
This gauge (Fig. 24) indicates the engine coolant
temperature.
Speed Limiter
Adjust the screw (Fig. 25) to limit the amount the traction
pedal can be depressed in the forward direction to limit
speed.
Figure 25
1. Speed limiter
Lift Levers
The levers (Fig. 26) raise and lower the cutting units.
Cutting Unit Service Lock
The cutting unit service lock (Fig. 26) locks the front
cutting unit lift lever when the cutting unit is in the raised
position.
Key Switch
The key switch (Fig. 26) has three positions: Off,
On/Preheat, and Start.
PTO Switch
The PTO switch (Fig. 26) has three positions: On (engage),
Neutral, and Off (disengage). Carefully lift and push the
PTO switch forward to the On position to start the
implement or cutting unit blades. Slowly pull the switch
backward to the Off position to stop implement operation.
Hi-Lo Speed Control
The control (Fig. 26) allows the speed range to increase for
transport of the machine.
Flow Divider Switch
Depress and hold flow divider switch (Fig. 26) to enhance
traction drive performance in compromised operating
conditions.
1
2
2
1. Lift lever
2. Front cutting unit service
lock
3. Key switch
4. PTO switch
5. Hi-lo speed control
6. Flow divider switch
7. Cruise control (optional)
Cruise Control (Optional)
The cruise control (Fig. 26) sets the speed of the machine.
Fuel Gauge
The fuel gauge (Fig. 26) indicates the level of fuel in the
tank.
26
8
7
4 5 6
1
10
11
12
3
14
Figure 26
8. Alarm silence switch
9. Temperature reset switch
10. Hour meter
11. Fuel gauge
12. Throttle
13. Audible alarm
14. Power point
9
13