Adjusting The Anti-Scalp Rollers - Toro 74997 Operator's Manual

Adjusting the Height-of-Cut Pin
Adjust the height-of-cut from 25 to 140 mm (1 to 5-1/2
inches) in 6 mm (1/4 inch) increments by moving the clevis
pin into different hole locations.
1. Move the transport lock to the L
2. Push on the deck-lift pedal with your foot and raise the
mower deck to the Transport position (also the 140
mm or 5-1/2 inch cutting-height position) as shown
in Figure 28.
3. To adjust, rotate the pin 90 degrees and remove the pin
from the height-of-cut bracket
4. Select a hole in the height-of-cut bracket corresponding
to the height-of-cut desired, and insert the pin
28).
5. Push on the deck lift, pull back on the transport lock,
and slowly lower the mower deck.
Figure 28
1. Deck-lift pedal
2. Height-of-cut pin
Adjusting the Anti-Scalp
Rollers
Whenever you change the height-of-cut, it is recommended
to adjust the height of the anti-scalp rollers.
1. Disengage the blade-control switch (PTO), move the
motion-control levers to the N
and set the parking brake.
2. Shut off the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Adjust the anti-scalp rollers as shown in
Figure 30, and Figure
position.
OCK
(Figure 28).
(Figure
3. Transport lock
- position,
EUTRAL LOCK
Figure
31.
1. Anti-scalp roller
2. Spacer
3. Bushing
1. Anti-scalp roller
2. Bushing
g029957
1. Anti-scalp roller
2. Spacer
3. Bushing
29,
27
g029955
Figure 29
4. Flange nut
5. Bolt
g029956
Figure 30
3. Flange nut
4. Bolt
Figure 31
4. Flange nut
5. Bolt