Controls System Maintenance; Adjusting The Control-Handle Position - Toro 74946 Operator's Manual

Controls System
Maintenance
Adjusting the Control-Handle
Position
There are 2 height positions for the control levers—high and
low. Remove the bolts to adjust the height.
1. Disengage the blade-control switch (PTO), move the
motion-control levers to the N
and set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Loosen the bolts and flange nuts installed in the levers
(Figure 80).
4. Align the levers in the front-to-rear position by bringing
the levers together to the N
until they are aligned, and tighten the bolts
Figure 80
1. Bolt
2. Handle
- position,
EUTRAL LOCK
position, slide them
EUTRAL
(Figure 81).
3. Control lever
4. Nut
5. If the ends of the levers hit against each other, refer
to Adjusting the Motion-Control Neutral-Lock Pivot
(page 59).
57
Figure 81