Starting Procedure; Setting The Video Signal; Av Input; Starting Procedure (For Av Source) - Pioneer AVH-X8890BT Owner's Manual

AUX source

Starting procedure

You can display the video image output by the device connected
to video input.
1 Display the "System" setting screen.
2 Touch [Input/Output Settings].
3 Confirm that "AUX Input" is turned on.
4 Display the AV source selection screen.
5 Touch [AUX].

Setting the video signal

When you connect this product to an AUX equipment, select the
suitable video signal setting.
The default setting is "Auto".
p You can operate this function only for the video signal input
into the AUX input.
1 Display the "Video Setup" screen.
2 Touch [Video Signal Setting].
3 Touch [AUX].
4 Touch the item.
The following items are available:
Auto, PAL, NTSC, PAL-M, PAL-N, SECAM.

AV input

Hides the touch panel keys.
To display again the keys, touch
anywhere on the screen.
CAUTION
For safety reasons, video images cannot be viewed while your vehicle is in
motion. To view video images, stop in a safe place and apply the handbrake.
Starting procedure (for AV
source)
You can display the video image output by the device connected
to video input.
 Refer to External video component on page 55
1 Display the "System" setting screen.
2 Touch [Input/Output Settings].
3 Touch [AV Input] repeatedly, set to "Source".
p If "Source" is selected, "2nd Camera Input" is automatically
set to "Off".
 Refer to Setting the second camera activation on page 39
4 Display the AV source selection screen.
5 Touch [AV].

Starting procedure (for camera)

You can display the image output by the camera connected to
video input.
 Refer to Camera on page 54
1 Display the "System" setting screen.
2 Touch [Input/Output Settings].
3 Touch [AV Input] repeatedly, set to "Camera".
4 Display the AV source selection screen.
5 Touch [Camera View].
p When the camera view of both the rear view camera and 2nd
camera are available, the key to switch the display appears.
Touch this key to switch the display between the rear view
image and 2nd camera image.
Setting the video signal
When you connect this product to an AV equipment, select the
suitable video signal setting.
The default setting is "Auto".
p You can operate this function only for the video signal input
into the AV input.
1 Display the "Video Setup" screen.
2 Touch [Video Signal Setting].
3 Touch [AV].
4 Touch the item.
The following items are available:
Auto, PAL, NTSC, PAL-M, PAL-N, SECAM.
35