Table of Contents
Advertisement
Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
1
Adjusting the ROPS
No Parts Required
Procedure
1. Remove the hairpin cotter pins and remove the two
pins from the roll bar (Figure 4).
1
2
5
Right Side Shown
1. Roll bar
2. Pin
2. Raise the roll bar to the upright position and install
the two pins and secure them with the hairpin cotter
pins (Figure 4).
Description
No parts required
No parts required
No parts required
Operator's Manual
Engine Operator's Manual
Parts Catalog
Operator Training Material
Engine warranty
4
3
G004634
Figure 4
3. Hairpin cotter pin
Qty.
–
Adjust the ROPS.
–
Check the tire pressure.
Check the hydraulic fluid, engine oil,
–
and coolant levels.
1
Read the manuals and view the
1
training materials before operating the
1
machine. Use the remaining parts for
1
the installation of attachments.
1
Note: If you must lower the roll bar, push the bar
forward to relieve pressure on the pins, remove the
pins, lower the bar slowly, and secure it with the pins so
that it does not damage the hood.
WARNING
To avoid injury or death from rollover: keep the
roll bar in the raised locked position and use the
seat belt.
Ensure that the rear part of the seat is secured with
the seat latch.
WARNING
There is no rollover protection when the roll bar is
in the down position.
• Lower the roll bar only when absolutely
necessary.
• Do not wear the seat belt when the roll bar is
in the down position.
• Drive slowly and carefully.
• Raise the roll bar as soon as clearance permits.
• Check carefully for overhead clearances (i.e.
branches, doorways, electrical wires) before
driving under any objects and do not contact
them.
Important: Lower the roll bar only when absolutely
necessary.
14
Use
Advertisement
Table of Contents
