Maintenance; Recommended Maintenance Schedule - Toro 30411 Operator's Manual

Maintenance

Recommended Maintenance Schedule

Maintenance Service
Interval
After first 10 hours
After first 50 hours
Every 50 hours
Every 100 hours
After first 200 hours
Every 200 hours
Every 400 hours
Every 800 hours
Every 1500 hours or 2
years, whichever occurs
first
1
If the indicator shows red
Important Refer to your engine operator's manual for additional maintenance procedures.
Maintenance Procedure
• Check the cutting unit drive belt tension.
• Check the fan and alternator belt tension.
• Torque the wheel lug nuts.
• Change the engine oil and filter.
• Check the engine RPM (at idle and full throttle).
• Torque the lock nuts on pivots.
• Lubricate all grease fittings.
• Inspect the air cleaner.
• Check the battery level and cable connections.
• Check the cutting unit drive belt tension.
• Clean underside of mower housing and under belt covers
• Change the engine oil and filter.
• Inspect the cooling system hoses.
• Check the fan and alternator belt tension.
• Change the hydraulic oil.
• Change the hydraulic oil filters.
• Change the front planetary and brake gear lube.
• Change the rear axle oil.
• Torque the wheel lug nuts.
• Service the spark arrestor.
1
• Service the air filter.
• Change the fuel filters (fuel/water and prefilter).
• Inspect the fuel lines and connections.
• Check the engine RPM (at idle and full throttle).
• Check the rear axle oil level.
• Check the front planetary and brake gear lube.
• Drain and clean the fuel tank.
• Change the hydraulic oil.
• Change the hydraulic oil filters.
• Change the front planetary and brake gear lube.
• Change the rear axle oil.
• Inspect the cutting unit drive belts.
• Inspect the cutting unit castor wheel assemblies.
• Check the rear wheel toe-in.
• Check and adjust the valve clearance.
• Replace moving hoses.
• Replace safety switches.
• Flush the cooling system and replace fluid.
31