Checking The Spark Arrester; Fuel System Maintenance; Replacing The Fuel Filter - Toro 74942TE Operator's Manual

With 152cm turbo force rear discharge mower
Hide thumbs Also See for 74942TE:
Table of Contents

Advertisement

Installing the Spark Plug
Tighten the spark plug(s) to 24.4 to 29.8 N·m (18 to 22 ft-lb).
Figure 53

Checking the Spark Arrester

For a Model with a Spark Arrester
Service Interval: Every 50 hours
WARNING
Hot exhaust system components may ignite
gasoline vapors even you shut off the engine. Hot
particles exhausted during engine operation may
ignite flammable materials. Fire may result in
personal injury or property damage.
Do not refuel or run the engine unless a spark
arrester is installed.
1. Stop engine, wait for all moving parts to stop, and
remove key. Engage parking brake.
2. Wait for muffler to cool.
3. If there are any breaks in the screen or welds, replace
the arrester.
4. If the screen is plugged, remove the arrester and
shake the loose particles out of the arrester and clean
the screen with a wire brush (soak it in solvent if
necessary). Install the arrester on the exhaust outlet.
Fuel System
Maintenance

Replacing the Fuel Filter

Service Interval: Every 500 hours/Yearly (whichever comes
first) (more often in dirty or dusty
conditions).
The fuel filter is located near the engine on the front or rear
side of the engine.
1. Disengage the blade-control switch (PTO), move the
motion-control levers to the N
and set the parking brake.
2. Shut off the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Wait for the machine to cool down.
4. Close the fuel-shutoff valve under the seat
5. Squeeze the ends of the hose clamps together and slide
them away from the filter
G008963
1. Fuel filter
2. Hose clamp
6. Remove the filter from the fuel lines.
7. Install a new filter and move the hose clamps close to
the filter
(Figure
8. Open the fuel-shutoff valve.
Important: Install the fuel line hoses and secure with
plastic ties the same as they were originally installed at
the factory to keep the fuel line away from components
that can cause fuel line damage.
40
-
EUTRAL
LOCK
(Figure
54).
1 2
3
Figure 54
3. Fuel line
54).
position,
(Figure
18).

Advertisement

Table of Contents
loading

This manual is also suitable for:

Z master professional 6000 series

Table of Contents