Table of Contents
Advertisement
Figure 81
1. Clutch pulley
2. Mower belt
3. Spring loaded idler pulley
4. Ratchet
12. Install the belt guide on the idler arm shown in
81.
13. Using the ratchet in the square hole, install the idler
spring
(Figure
81).
Make sure that the spring ends are seated in the anchor
grooves.
14. Install the belt covers and the bolts attached to them
(Figure
82).
5. Square hole in the idler
arm for the ratchet
6. Idler grease fitting
7. Belt guide
Figure
1. Position the belt cover
2. Slide belt cover under the
side catches
15. Install the Mower-Deck Curtain. Refer to
Mower-Deck Curtain (page
16. Install the Sheet-Metal Guard. Refer to
Sheet-Metal Guard (page
Inspecting the Belts
Service Interval: Every 50 hours
Check the belts for squealing when the belt is rotating, blades
slipping when cutting grass, frayed belt edges, burn marks and
cracks are signs of a worn mower belt. Replace the mower
belt if any of these conditions are evident.
Replacing the Hydraulic Pump
Drive Belt
1. Disengage the PTO and set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Remove mower belt. Refer to
Belt (page
51).
4. Raise the machine and support it with jack stands
(Figure
83).
52
Figure 82
3. Tighten the bolt
Releasing the
33).
Removing the
33).
Replacing the Mower
Advertisement
Table of Contents
