Stopping The Machine; Adjusting The Height Of Cut - Toro 74939 Operator's Manual

Driving Forward
Note: The engine will kill if the traction control levers are
moved with the parking brake engaged.
To stop, pull the motion control levers to the neutral position.
1. Release the parking brake; refer to Releasing the
Parking Brake (page 18).
2. Move the levers to the center, unlocked position.
3. To go forward, slowly push the motion control levers
forward (Figure 23).
Figure 23
Driving Backward
1. Move the levers to the center, unlocked position.
2. To go backward, slowly pull the motion control levers
rearward (Figure 24).

Stopping the Machine

To stop the machine, move the traction control levers to
neutral and move to locked position, disengage the power
take off (blade control switch (PTO), and turn the ignition
key to off.
Set the parking brake when you leave the machine; refer to
Setting the Parking Brake (page 18). Remove the key from
the ignition switch.
G008952 CAUTION
Children or bystanders may be injured if they
move or attempt to operate the machine while it is
unattended.
Always remove the ignition key and set the parking
brake when leaving the machine unattended, even
if just for a few minutes.

Adjusting the Height of Cut

Using the Transport Lock
The transport lock has 2 positions and is used with the deck
lift pedal. There is a lock position and a unlock position for
the transport position. The transport lock is used with the
deck lift pedal. Refer to Figure 25.
23
G008953
Figure 24