1
2
Figure 22
1. Front access cover
5. When finished, replace the front access cover and
secure it with the two locking tabs.
Opening the Rear Access Cover
1. Stop the engine and remove the key.
2. Release the two locking tabs on top of the rear access
cover (Fig. 23).
2
Figure 23
1. Rear access cover
2. Locking tabs
3. Remove the bolt located next to the right locking tab
(Fig. 23).
4. Grasping the handle, pull the cover up and back to
swing it open (Fig. 23).
5. When finished, close the rear access cover by
swinging it up and seating it in place.
6. Secure it with the two locking tabs and bolt
m–4595
2. Locking tabs
3
1
3. Bolt
25
Greasing the Traction Unit
Grease all pivot joints every 8 operating hours and
immediately after every washing.
Grease Type: General-purpose grease.
1. Lower the loader arms and stop the engine. Remove
the key.
2. Clean the grease fittings with a rag.
3. Connect a grease gun to each fitting
(Fig 24 and 25).
Figure 24
Figure 25
4. Pump grease into the fittings until grease begins to
ooze out of the bearings (approximately 3 pumps).
5. Wipe up any excess grease.
Servicing the Air Cleaner
Clean the primary filter every 25 operating hours.
Replace the primary and secondary filter yearly.
Note: Service the air cleaner more frequently if operating
conditions are extremely dusty or sandy.
m–4396
m–4056