Installing And Removing Attachments - Toro 22303 Operator's Manual

Removing/Storing the Cylinder Locks
1. Start the engine.
2. Raise the loader arms to the fully raised position.
3. Stop the engine.
4. Remove the clevis pin and cotter pin securing
each cylinder lock.
5. Remove the cylinder locks.
6. Lower the loader arms.
7. Install the cylinder locks over the hydraulic
hoses and secure them with the clevis pins and
cotter pins (Fig. 17).
1
2
Figure 17
1. Hydraulic hoses
2. Cylinder locks
Installing and Removing
Attachments
Connecting an Attachment
IMPORTANT: Use only Toro approved
attachments. Attachments can change the
stability and the operating characteristics of
the traction unit. The warranty of the traction
unit may be voided if used with unapproved
attachments.
3
4
1
2
m–4601
3. Hairpin cotter
4. Clevis pin
IMPORTANT: Before installing the
attachment, ensure that the mount plates are
free of any dirt or debris.
1. Position the attachment on a level surface with
enough space behind it to accommodate the
traction unit.
2. Move the speed selector lever to the turtle
position.
3. Start the engine.
4. Slowly push the attachment tilt lever forward to
tilt the attachment mount plate forward.
5. Position mount plate into the upper lip of the
attachment receiver plate (Fig. 18).
2
Figure 18
1. Mount plate
6. Raise the loader arms while tilting back the
mount plate at the same time.
IMPORTANT: The attachment should be
raised enough to clear the ground, and the
mount plate should be tilted all the way back.
7. Stop the engine.
8. Engage the quick attach pins (Fig. 19).
9. Ensure that the cam collars are seated on top of
the cast pin brackets (Fig. 19).
Operation
1
m–4055
2. Receiver plate
23