Stability Data - Toro 22303 Operator's Manual

Traction unit

Hide thumbs Also See for 22303:

Table of Contents

Check Before Operating

Stability Data

The following table lists the maximum slope recommended for the traction unit in the positions listed in the

table. Slopes over the listed degree may cause the traction unit to become unstable. The data in the table

assumes that the loader arms are fully lowered and that the factory installed tires are on the traction unit, inflated

to the recommended pressure; raised arms and other tire types or pressure may affect the stability.

Configuration

Traction unit without attachment

Traction unit with counterweight, without attachment

Traction unit with an attachment rated with one of the following

stability ratings for each slope position:*

* In each attachment manual is a set of three stability ratings, one for each hill position. To determine the

maximum slope you can traverse with the attachment installed, find the degree of slope that corresponds to the

stabilities ratings of the attachment.

Example: If the attachment installed on the traction unit has a Front Uphill rating of B, a Rear Uphill rating of

D, and a Side Uphill rating of C, then you could drive forward up an 18 slope, rearward up a 10 slope, or

sideways on a 14 slope, as listed in the above table.

Maximum Recommended Slope

when Operating with:

Front Uphill

Rear Uphill

Side Uphill

Table of Contents

Dingo 320-d