Auger Cable Adjustment
1. The auger cable adjustment should be checked after
the first 2 hours of use and annually thereafter. To
begin, ensure the auger lever is in the full
up position.
2. Loosen the jam nut. The cable is adjusted using the
turnbuckle on the lower end of the auger cable.
NOTE
When rotating the turnbuckle, hold the cable so it does
not twist.
3. Remove the belt cover. Adjust the turnbuckle until
there is a 1/16" (1.5mm) gap between the stop and
the auger clutch assembly. Secure the jam nut on
the turnbuckle.
Walk-Behind Rotary Broom Service Manual
Traction Control
The traction bail is on the left handle and when
squeezed engages the wheel drive system.
Fig. 007
Fig. 008
CONTROLS
Fig. 009
3-5