1
Figure 45
1. Actuator
2. Actuator rod
3. Boom pivot pin housing
3. Lift up on the boom and remove the pin (Figure 45).
Slowly lower the boom to the ground.
4. Inspect the pin for any damage, replace if necessary.
5. Manipulate the actuator rod bearing end and apply
grease into the bearing (Figure 46). Wipe off excess
grease.
Figure 46
Right boom
1. Grease bearing
6. Raise the boom to align the pivot with the actuator
rod. While holding the boom, insert the pin through
both boom pivot and actuator rod (Figure 45).
4
2
5
3
G002016
4. Cotter
5. Pin
7. With the pin in place, release the boom and secure
the pin with the cotter removed previously.
8. Repeat the procedure for each actuator rod bearing.
43