Functional Specification - Kenwood DDX6034 Service Manual

2.3.15. Bluetooth Confi rmation screen
Perform LOOPBACK test with the other Bluetooth device in
the line.
The Bluetooth Confirmation screen is displayed in Figure
2.3.15.
• Select one device that is used as a counterpart of the
LOOPBACK test from the device list displayed on the
screen. (The selected device is highlighted with the dif-
ferent color from others.)
• Start the LOOPBACK test when "Complete" is displayed
in the stats display area.
• After the completion of the LOOPBACK test, press [Clear]
key to initialize the fl ash memory and to set '0000' in PIN
Code. The "OK" indicates the completion of the test.
"NG" indicates that you have to enter in the Test mode
again to start over the test.
Bluetooth
Status Displayed Section
444444444444 Parrot
555555555555
OK/NG
666666666666
Clear
777777777777
888888888888
999999999999 Return
Figure 2.3.15 Bluetooth Confi rmation screen
Key Specifi cation
444444444444~999999999999
: Connect to the selected device (and then start
the LOOPBACK test after the completion of the
connection).
Parrot : Start the Parrot Check.
Clear : Initialize the fl ash memory and to set '0000' in
PIN Code.
Return : Transfer to Test Mode Main screen.
Status display specifi cation
Complete : Indicate the status that is ready to start
the LOOPBACK test after the completion
of the connection with the device.
Connect NG : If the connection with the device is failed,
select a device again and try to make the
connection with it.
* Select black for the background color until "Parrot OK/
NG" is displayed.
Modify the background color to blue at the same time as
"Parrot OK" is displayed.
Modify the background color to red at the same time as
"Parrot NG" is displayed.
TEST MODE
Parrot Check
Parrot OK/NG
Return
DDX6034/6034M/6054/7034BT/7034BTM/714
DNX7000EX/7140/7240BT/7340BT
* Details of the counter-machine for exclusive use of the
Test mode
Only Bluetooth Module selected as a counter-machine
is displayed on the device list to shorten the connection
time.
When a counter-machine is newly required due to a
failure or an expansion of the counter-machine, mount
Bluetooth Module having the address displayed in the
device list on the counter-machine without fail.
2.3.16. Navigation Update Check screen
This screen is used to check the USB connection with the
Garmin Navigation Board.
The Navigation Update Check screen is displayed in Figure
2.3.16.
Navigation Update Check
NAV Check
Cancel
Figure 2.3.16 Navigation Update Check screen
Key Specifi cation
NAV Check : Start check of the Navigation Update.
Cancel : Transfer to Test Mode Main screen.
Return : Transfer to Test Mode Main screen.
* Select black for the background color until "NAV OK/NG"
is displayed.
Modify the background color to blue at the same time as
"NAV OK" is displayed.
Modify the background color to red at the same time as
"NAV NG" is displayed.
2.4. Functional specifi cation
This section describes the test mode specifi cation in each
function.
2.4.1. Display
Although this screen is used for exclusive use in the Test
mode, the screens including the Source Control/Audio
Control/Setup screen etc. are the same as while in normal
operation.
As for the display of the Touch cursor, perform operation in
the same way as while in normal operation.
The [Multi Function] key of each Source control screen is
set as the displayed state. (The drawer of Multi Function is
set as the Open state)
Navigation Update Check
NAV OK/NG
Return
21