Logging In To The Ap Using Telnet - Huawei AP3010DN-AGN Hardware Installation And Maintenance Manual

Huawei AP3x10xN&5x10xN&5x30xN&6x10xN&7x10xN
Hardware Installation and Maintenance Guide
3.

3.3 Logging In to the AP Using Telnet

This section describes how to log in to the AP using Telnet. After logging in to the AP, you can
configure the AP using commands.
1.
2.
3.
4.
5.
Issue 11 (2015-05-18)
Click Open. Enter the user name and password at the prompt, and press Enter. You have
logged in to the device. (The following information is only for reference.)
login as: admin
Sent username "admin"
admin@169.254.1.1's password:
<Huawei>
NOTE
It is recommended that you change the initial user name and password after login.
NOTE
l In V200R005C00 and later versions, upon factory delivery, the Telnet server is disabled. Before
connecting to the device through Telnet from a user terminal, make sure that the Telnet service is
enabled on the device by the STelnet service.
l The Telnet protocol poses a security risk, and therefore the STelnet protocol is recommended.
Connect a PC to the ETH/PoE interface of the AP using a network cable.
Configure a static IP address for the PC. The IP address must be in the same network
segment as the AP's IP address. After completing the configuration, ping the AP's IP address
from the PC. If the ping operation succeeds, the connection is set up successfully. If the
ping operation fails, check whether the network cable is faulty.
NOTE
l In V200R002C00 and earlier versions, the IP address 192.168.0.1 and subnet mask 255.255.255.0
have been configured on VLANIF 1 of the AP before the delivery, and GE0/0/1 has been added to
VLAN 1 by default.
l In V200R003C00 and later versions, the IP address 169.254.1.1 and subnet mask 255.255.0.0 have
been configured on VLANIF 1 of the AP before the delivery, and GE0/0/1 has been added to VLAN
1 by default.
l If the AP working in Fit AP mode is online on the AC, the DHCP server automatically assigns an IP
address to the AP. You can remotely log in to the AC on a local terminal and run the following
command to check the AP's IP address:
l For V200R005C30 and earlier versions: display ap-run-info id ap-id
l For V200R006C00: display ap run-info ap-name ap-name
Enter the command line interface on the PC. For example, in Windows XP, choose Start
> Run and enter cmd in the displayed dialog box.
Use Telnet to log in to the AP.
Enter the default user name admin. The initial password is admin in V200R002C00 and
earlire versions and is admin@huawei.com in V200R003C00 and later versions. If the
user view is displayed, you have logged in successfully. You are advised to change the user
name and password on your first login.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Logging In to the AP
33