Samsung np-q1ex User Manual page 190

The screen may not be displayed
or only part of the screen may be
displayed when the LCD resolution is
too low or too wide and the projector
cannot support the resolution. In this
case, right-click over the Desktop,
select Personal Settings > Display
Settings (Y), set the resolution to 800
x 600 pixels and then try again.
I have connected a monitor (or
Q
projector) to the computer, but
the colors on the monitor are
abnormally displayed.
A Check if the monitor and computer
are properly connected with the signal
cable and reconnect the cable if
necessary.
The picture on the screen
Q
trembles.
A The picture on the screen may
tremble when you view some Internet
pages or play some on-line games. In
this case, using an external monitor is
recommended.
Organizer Related
When I connect an external
Q
display and change the settings
to display the screen image on
both the LCD and the external
display by pressing the Fn +
key combination, the screen is not
displayed properly.
A Press Fn +
again. If the screen is still not
displayed or only part of the screen
is displayed by doing this, that means
the LCD resolution is too low or too
wide and the external display support
the resolution. Right-click over the
Desktop, select Properties, select
the Settings tab and change the
resolution to 800 x 600.
The Taskbar on the bottom of the
Q
screen does not appear when a
projector is used as the display
device.
A This may happen, if the projector
does not support LCD resolution. In
this case change the resolution to
800 x 600 (recommended) on your
computer.
190
key combination