Charging The Battery - Husqvarna 105 Operator's Manual

Installation and connecting the charging
station
1. Position the charging station in a suitable spot.
2. Connect the low voltage cable to the charging
station.
3. Connect the power supply's power cable to a
100-240 V wall socket. If the wall socket is
outdoors, it is important that the power supply is
protected from direct sunlight.
4. Attach the charging station to the ground using
the supplied screws. Ensure the screws are
screwed all the way down in the countersink.
IMPORTANT INFORMATION
It is not permitted to make new holes in the
base plate Only the existing holes may be
used to secure the base plate to the ground.
IMPORTANT INFORMATION
Do not tread or walk on the charging station's
base plate.

3.3 Charging the battery

As soon as the charging station is connected, it is
possible to charge the robotic lawnmower. Set the
main switch to position 1.
Place the robotic lawnmower in the charging station
to charge the battery while the boundary and guide
wires are being laid.
If the battery is flat, it takes around 80 to 100 minutes
to fully charge it.
IMPORTANT INFORMATION
The robotic mower cannot be used before
the installation is complete.
3. INSTALLATION
3012-984
3012-937
3012-938
3012-939
English - 23