Installation Of The Charging Station - Husqvarna 105 Operator's Manual

• Low voltage cable (26)
• Pegs (19)
• Connector for connecting the loop wire to the
charging station (18)
• Screws for the charging station (21)
• Measurement gauge (26)
• Couplers for the loop wire (20)
During installation you will also need:
• Hammer/plastic mallet (to simplify putting the
pegs in the ground).
• Combination pliers for cutting the boundary
wire and pressing the connectors together.
• Polygrip (for pressing the couplers together).
• Edge cutter/straight spade if the boundary wire
must be buried. Installation of the charging
station.
3.2 Installation of the charging
station
Ideal position for the charging station
Take the following aspects into consideration when
identifying the best location for the charging station:
• Allow for 3 metres of free space in front of the
charging station.
• It must be possible to lay at least 1.5 metres of
boundary wire straight out to the right and left
of the charging station.
• It must be close to a wall socket The supplied
low voltage cable is 10 metres long.
• A level surface to place the charging station
on.
• Protection from water spray for instance from
irrigation.
• Protection from direct sunlight.
• Place in the lower part of a working area that
has a major slope.
For an example of an ideal position of the charging
station, see 7. Garden examples on page 56.
3. INSTALLATION
3012-1311
3018-072
English - 19