Cleaning Oven Surfaces; Maintenance; Replacing The Oven Light - Bosch 700 Series Use And Care Manual

Table 7: Oven Surface Cleaning
Surface
Racks
(Oven)
Fiberglass Knit
(Gasket)
Glass
Cleaning Oven Surfaces
Methods
Cleaning Method
Wash with hot sudsy water. Rinse thoroughly and dry, or gently rub with cleansing
powder or soap filled pads as directed. If racks are cleaned in the oven during the self-
clean mode, they will lose their shiny finish and may not glide smoothly. If this happens,
wipe the rack edges with a small amount of vegetable oil, then wipe off excess. DO NOT
self clean the extendable rack.
DO NOT HAND CLEAN GASKET.
Wash with soap and water or glass cleaner. Use Fantastik® or Formula 409® to remove
(Window, Display)
Painted
(Exterior)
Porcelain
(Interior)
Stainless Steel
(Exterior)
Plastic
(Knobs, Controls)
grease spatters and stubborn stains.
Clean with hot sudsy water or apply Fantastik® or Formula 409® to a clean sponge or
paper towel and wipe clean. Avoid using powdered cleansers, steel wool pads and oven
cleaners.
Immediately wipe up acid spills like fruit juice, milk and tomatoes with a dry towel. Do
not use a moistened sponge/towel on hot porcelain. When cool, clean with hot sudsy
water or apply Bon-Ami® or Soft Scrub® to a damp sponge. Rinse and dry. For stubborn
stains, gently use soap filled pads. It is normal for porcelain to craze (fine lines) with age
due to exposure from heat and food soil.
Always wipe or rub with grain. Clean with a soapy sponge then rinse and dry, or wipe
with Fantastik® or Formula 409® sprayed onto a paper towel. Protect and polish with
Stainless Steel Magic® and a soft cloth. Remove water spots with a cloth dampened with
white vinegar. Use Bar Keeper's Friend® to remove heat discoloration.
When cool, clean with soapy water, rinse and dry.
Replacing the Oven Light
• Each oven is equipped with two halogen lights located in the back wall of the oven.
• The lights are switched on when the door is opened or when the oven is in a cooking cycle.
• The oven lights do not operate during self-clean.
• Each light assembly consists of a removable lens, a light bulb and a light socket housing that is fixed in place
(see Figure 23, next page).
To replace a light bulb (see figure 23, next page)-'
1. Read WARNING on this page.
2. Turn off power at the main power supply (fuse or
breaker box).
3. Unscrew lens and remove.
4. Pull straight out on light bulb to remove from
socket.
_, WARNING
Make sure the oven and lights are cool and
power to the oven has been turned off before
replacing the light bulb(s). Failure to do so
could result in electrical shock or burns.
The lenses must be in place when using the
oven.
• The lenses serve to protect the light bulb from
breaking.
• The lenses are made of glass. Handle carefully
to avoid breaking. Broken glass could cause an
injury.
• Light socket is live when door is open.
.
Replace the bulb with a new one. Avoid pressing
the bulb with fingers (grasp with a tissue instead);
Oils from hands can damage the bulb when it
becomes hot
6. The bulb is halogen 12V - 20W.
7. Screw the lens back on.
8. Turn power back on at the main power supply
(fuse or breaker box).
English • 19