Info Messages - Husqvarna AUTOMOWER 315 Operator's Manual

9.2 Info messages

A number of info messages are listed below that can be shown on the display on the robotic lawnmower. It is
recommended to contact your dealer if the same message appears often. Check that the installation is performed
as described in the Operator's Manual. Then contact your local dealer.
Message
Low battery
Settings restored
Guide not found
Guide calibration
failed
Guide calibration
accomplished
Difficult finding home
OM_1157863-26_HQ 310,315,EN_160229.indd 77
TROUBLESHOOTING
Cause
The robotic lawnmower cannot find
the charging station.
The guide wire is broken or not
connected.
The battery is spent.
The charging station's antenna is
defective.
Confirmation that a Reset all user
settings has been carried out.
The guide wire is not connected to
the charging station.
Break in the guide wire.
The guide wire is not connected to
the boundary loop.
The robotic lawnmower has failed to
calibrate the guide wire.
The robotic lawnmower has
succeeded to calibrate the guide wire.
The robotic lawnmower has been
following the boundary wire several
laps without finding the charging
station.
Action
Check that the charging station and the guide wire
are installed in accordance with the instructions.
See 3 Installation on page 16.
Find out where the break is and rectify it.
Contact your dealer to test or possibly replace the
battery.
Check if the indicator lamp in the charging station
flashes red. See 9.3 Indicator lamp in the charging
station on page 78.
This is normal. No action required.
Check that the guide wire's connector is tightly
connected to the charging station. See 3.6
Installation of the guide wire on page 29.
Find out where the break is. Replace the
damaged section of the guide wire with a new
loop wire and splice using an original coupler.
Check that the guide wire is connected correctly
to the boundary loop. See 3.6 Installation of the
guide wire on page 29. Splice using an original
coupler.
Check that the guide wires are installed according
to the instructions, See 3.6 Installation of the
guide wire on page 29
No action required.
The installation has not been done correctly.
See Laying the boundary wire on page 25.
Wrong corridor width setting on boundary wire.
See Finding the charging station on page 13.
The mower was started on a Secondary area with
the Main area setting.
English - 77
2016-02-29 10:52:39