Husqvarna AUTOMOWER 315 Operator's Manual page 32

Laying and connecting the guide wire
1. Before laying and connecting the guide wire, it
is important to give consideration to the length
of the guide loop, especially in large or complex
installations. If the guide loop is longer than 400
metres the robotic lawnmower can have difficulty
following the guide wire.
The guide wire together with the section of the
boundary loop that makes up the return wire
to the charging station is called the guide loop.
The current in the guide loop always goes to the
left at the connection from the guide wire to the
boundary loop. The two figures here display what
is regarded as a guide loop. The figures are also
a good example of how the guide loop in a working
area can have very varying lengths depending on
where the charging station is placed.
2. Tilt the top cover on the charging station forward
and run the guide wire up the channel leading to
the guide connection.
3. Fit a connector to the guide wire in the same
way as for the boundary wire in 3.5 Connecting
the boundary wire on page 27. Connect it to the
contact pin on the charging station that is labelled
G1.
4. Mark the wires with the accompanying cable
markers. This makes it easier to reconnect the
wires correctly when for instance the charging
station has been stored indoors for the winter.
5. Run the guide wire straight under the charging
plate and then at least 2 metres straight out from
the front edge of the plate.
Consider when laying the guide wire that as much
space as possible is provided to the left (as seen
facing the charging station) of the guide wire.
The distance between the boundary loop and
the guide wire must however be always at least
30 cm.
English - 30
OM_1157863-26_HQ 310,315,EN_160229.indd 30
INSTALLATION
G1
Min 2 m/7 ft
Maximum
distance
Min 30 cm/12"
Min 2 m/7 ft
3023-009
3023-010
3012-1326
3023-011
2016-02-29 10:51:52