GE JSP26 Use And Care Manual page 22

Broiling is cooking food by intense radiant heat
from the upper broil element in the oven. Most
fish and tender cuts of meat can be broiled. Follow
these directions to keep spattering and smoking to
a minimum.
1. If the meat has fat or gristle around the edge, cut
vertical slashes through both about 2 inches apart.
If desired, the fat may be trimmed, leaving a layer
about 1/8 inch thick.
2. Place the meat on the broiler rack in the broiler pan.
Always use the rack so the fat drips into the broiler
pan; otherwise the juices may become hot enough
to catch on fire.
3. Position a flat shelf on recommended shelf position
as suggested in the Broiling Guide. Most broiling is
done on C position, but if your range is connected
to 208 volts, you may wish to use a higher position.
4. the door open to the
Leave
broil stop position. The door
stays open by itself, yet the
proper temperature is
maintained in the oven.
Use of Aluminum Foil
You can use aluminum foil to line
your broiler pan and broiler rack.
However, you must mold the foil
tightly to the rack and cut slits in it
just like the rack.
Questions and Answers
Q. Should I salt the meat before broiling?
A. No. Salt draws out the juices and allows them to
evaporate. Always salt after cooking. Turn the
meat with tongs; piercing the meat with a fork also
allows the juices to escape. When broiling poultry
or fish, brush each side often with butter.
Q. Do I need to grease my broiler rack to prevent
meat from sticking?
A.
No. The broiler rack is designed to reflect broiler
heat, thus keeping the surface cool enough to
prevent the meat from sticking to the surface.
However, spraying the broiler rack lightly with a
vegetable cooking spray before cooking will make
clean-up easier.
22
BROILING
. . . .
Without the slits, the foil will
prevent fat and meat juices from
draining to the broiler pan. The
juices could become hot enough to
catch on fire. If you do not cut the
slits, you are frying, not broiling.
Turn the food only once during broiling. Time the
foods for the first side according to the Broiling
Guide. Turn the food, then use the times given for
the second side as a guide to the preferred doneness.
BROIL
u
6. Press the INCREASE pad once for LO Broil or
twice for HI Broil.
To change from HI Broil to LO Broil, press the
BROIL pad then press the DECREASE pad once.
7. When broiling is finished, press the CLEAIUOFF
pad. Serve the food immediately, and leave the
pan outside the oven to cool during the meal for
easiest cleaning.
"
NOTE: A fan may automatically turn on and off
to cool internal parts. This is normal and the fan may
continue to run after the oven is turned off.
Q. When broiling, is it necessary to always use a
rack in the pan?
A. Yes. Using the rack suspends the meat o~-er the
pan. As the meat cooks, the juices fall into the pan,
thus keeping the meat drier. Juices are protected by
the rack and stay cooler, thus preventing excessive
spatter and smoking.
Q. Why are my meats not turning out as brown as
they should?
A. In some areas, the power (voltage) to the range may
be low. In these cases, preheat the broil element for
10 minutes before placing the broiler pan with food -
in the oven. Check to see if you are using the
recommended shelf position. Broil for the longest
period of time indicated in the Broiling Guide. Turn
the food only once during broiling. You may need
to move the food to a higher shelf position.
—
/)