Log On Contiguous Series Of Cards - Siemens RF30-EM Configuration Manual

11.1.3 Log on contiguous series of cards

Siemens AG
NOTE
If you have entered the wrong Axx command (e g in step 3 below) you can abort the command and
exit to Administrator mode by pressing A again.
1. Press B .

2. Enter the 6-digit Administrator code. See section 8 Change Administrator
code.

3. Press A04 .
 The buzzer sounds a confirm tune.

- or -
 If the memory is full, the buzzer will sound an error tune and return to
Administrator mode.

4. Enter the the card number of the first card (last 8-digits) in the series.
 The buzzer sounds a confirm tune.

5. Enter the card number of the last card (last 8-digits) in the series.
 The buzzer sounds a confirm tune.
 LED 1 flashes red continuously as the cards are logged on.
- or -
 If the memory is full or the first number is greater than the second number, the
buzzer will sound an error tune and return to Administrator mode.

Stand-alone mode
23
04.2010