ET1 Enterprise Tablet User Guide
3
Press and hold either Scan/Action button.
The red laser aiming pattern turns on to assist in aiming. Ensure the bar code is within the area formed by the
cross-hairs in the aiming pattern. The aiming dot is used for increased visibility in bright lighting conditions.
The Scan/Decode LED lights red to indicate that scanning is in process, then lights green, a beep sounds and the
ET1 vibrates, by default, to indicate the bar code was decoded successfully. Note that when the ET1 is in Pick
List Mode, the ET1 does not decode the bar code until the center of the crosshair touches the bar code.
Figure 3-2 Aiming Pattern
Figure 3-3 Pick List Mode with Multiple Bar Codes in Aiming Pattern
Release the scan button.
4
5
The captured data appears in the text field.
3.6 Bar Code Capture with Integrated Camera
Procedure Steps
Ensure that an application is open on the ET1 and a text field is in focus (text cursor in a text field).
1
2
Aim the rear-facing camera at a bar code.
3-4
MN000022A01 - May 2013