Table of Contents
Advertisement
PAPER HOLD
Sets to hold the printed paper or not.
OFF
Printed paper is cut and released.
ON
Printed paper is held at the print outlet after cut. Pull the paper out when
necessary.
•
When selecting THERMAL : ON, this menu changes to AUTO CUT.
•
It is recommended not to leave the printed paper holding at the print outlet. Some
malfunction may occur.
•
Do not turn off the power while holding paper.
•
When PAPER HOLD is set to ON, MENU button and COLOR ADJUST button on
the remote control unit are not available.
AUTO CUT
Selects cutting the printed thermal paper automatically or not.
ON
Cuts the printed thermal paper automatically.
OFF
Does not cut the thermal paper. Press MEMORY button while
pressing MONITOR button.
•
This menu is displayed only when THERMAL : ON is selected.
INIT PRG (Initialize program)
ALL
Mode to initialize the program in MAIN MENU and SERVICE MENU.
MAIN
Mode to initialize the program in MAIN MENU.
SERVICE Mode to initialize the program in SERVICE MENU.
INITIALIZE
OFF
Does not initialize.
GO[SET] Starts initializing. When SET button is pressed, initializing starts.
Setting and type of print paper / Print result
Type of print paper
Setting
PAPER
AUTO
MARGIN
THERMAL
HOLD
CUT
CUT
OFF
OFF
OFF
Not displayed
OFF
OFF
ON
Not displayed
OFF
ON
OFF
Not displayed
OFF
ON
ON
Not displayed
ON
ON
OFF
Not displayed
ON
OFF
OFF
Not displayed
* 1, * 2
This error is displayed when turning the power on, and closing the door.
* 3
In this case, remove the thermal paper and install the colour print paper.
* 4
In this case, remove the colour print paper and install the thermal paper.
•
When setting THERMAL to OFF after thermal printing with setting AUTO CUT to
OFF, "PUSH FEED&CUT5" is displayed on the monitor. In this case, press MEMORY
button with holding MONITOR button to cut the printed paper.
•
When selecting AUTO CUT : OFF, make sure to cut the printed paper before turning
off the power.
GAMMA ADJ Gamma level setting display
INIT : [CLEAR]
Initializes each setting.
COLOR
Selects the adjusting gamma level.
ALL
Adjusting gamma level for all colours.
EACH
Adjusting gamma level for each colour of R, G, B.
SELECT
Is displayed when selecting "EACH" in COLOR.
R
Adjusting gamma level for red.
G
Adjusting gamma level for green.
B
Adjusting gamma level for blue.
Changing gamma curve:
Use the {,} buttons on the remote control unit to select the Hi/Mid/Low gamma
point to set.
Also use [, ] buttons to input setting level.
Colour print paper
With ink cassette
Normal colour print
Normal colour print with Margin cut
Normal colour print with Paper hold
Normal colour print with Paper hold after margin cut
Printing is not available.
REMOVE CASS TML *2
NOTE
Monochrome thermal paper
Without ink cassette
With ink cassette Without ink cassette
Does not print
Printing is not
Printing is not
available.
correctly.
available.
CHECK CASSETTE
*3
CHECK CASSETTE
*1
*1
Printing is not
Cuts after thermal
Does not print
printing
available.
correctly.
Does not cut after
REMOVE CASS TML
*4
thermal printing
*2
GAMMA ADJ INIT : [CLEAR]
COLOR
ALL/EACH
SELECT
R/G/B
Hi
0
Mid
0
Low
0
POINT 64
128 192
39
Advertisement
Table of Contents
