Hitachi PB Series User Manual page 30

2–6 2.1 Startup
5. Make sure that the ink beam is positioned in the center of the gutter both
horizontally and vertically as shown in the following figure.
If the ink beam is not positioned in the center of the gutter, perform step 1 to stop the
ink ejection, and then proceed as described in
Manual, "Correcting a Bent Ink Beam and Clogged Nozzle".
When checking the ink beam position, wear protectors (goggles and mask).
If the ink or makeup ink should enter your eyes or mouth, immediately flush with
warm or cold water and see a physician.
Before ejecting the ink, ensure that there is no person in the path of ejection.
(The end of the print head must be placed in a beaker or similar.)
6. Install the print head cover.
If the "Cover open" fault is indicated, press the [Erase message] key.
7. Wait until the status changes to "Ready".
8. Input the print target detection signal and verify the printing results.
Section 2.1.1, "Starting an operation".)
(
Section 6.6 in the Instruction
DANGER
Section 2