Advertisement
HP 425 Wireless Dual Radio 802.11n Access Point Quickstart
AP status LEDs
LED color
State
Flashing
The AP is booting.
1 flash/sec.
Green
At least one client is connected to the 2.4
Fading in/out
GHz radio.
Flashing
The AP is updating its system software
2 flashes/sec.
image.
Flashing
The AP is booted and is registered to the
Blue
2 sec. on/
controller. There is no client connected.
2 sec. off
At least one client is connected to the 5 GHz
Fading in/out
radio.
On for more
An initialization exception has occurred.
than 20 sec.
Flashing
Orange
There is a problem with the radio module.
1 flash/sec.
Flashing
Both radios are disabled or the Ethernet port
2 flashes/sec.
is disabled while no local mesh peer exists.
Alternately
Clients are connected to both the 2.4 GHz
Green/Blue
fading green
and 5 GHz radios.
and blue
HP 425 optional antennas
Only the following antenna is approved for use with the AP:
Part
Type
Band
JG696A Omni-directional 2.4/5GHz 2.5/6dBi
Description
Gain
Use
Elements
Indoor
4
6
For external antennas only: Depending on the country of use and
Caution:
your radio settings, it may be mandatory to reduce the radio transmission
power level to maintain regulatory compliance. For specific power limits for
your country, see the HP 425 AP Antenna Power-Level Setting Guide available
from www.hp.com/support/manuals. Search by antenna part number.
For important safety, environmental, and regulatory information, see also
Safety and Compliance Information for Server, Storage, Power, Networking,
and Rack Products, available at:
www.hp.com/support/Safety-Compliance-EnterpriseProducts
© Copyright 2013 Hewlett-Packard Development
Company, L.P. The information contained herein is
subject to change without notice.
AP status LEDs
September 2013
Printed in
Document part # 5998-4326
*5998-4326*
Advertisement
