Advertisement
HP 425 Wireless Dual Radio 802.11n Access Point Quickstart
1.
Loosen, but do not remove all four M3 screws (7) on the clip holders (3).
1
2
3
5
6
7
1: T-rail clip
4: T-rail holder
2: M4 screw nut
5: M3 screw nut
3: Clip holder
6: M4 x 5 screw
2.
Slide the T-rail clips away from the T-rail holder until the opening is wider
than the T-rail (arrow 1).
1
3.
Attach the T-rail holder onto the T-rail, slide the T-rail clips toward the
T-rail holder until it closes around the T-rail (arrow 2), and then tighten
the M3 screws.
4.
Verify that the T-rail holder is firmly attached to the T-rail.
4
8
7: M3 x 8 screw
8: Mounting hook
2
4
5.
Hook the mounting bracket clip (3) onto the T-rail holder mounting hook (2).
1: M4 x 5 screw
2: Mounting hook
6.
Use the two M4 screws (6) to attach the mounting bracket to the T-rail
holder, and verify that the bracket is firmly anchored to the T-rail.
Proceed to Attach the AP on page 5.
Mounting on a ceiling tile
You can mount the AP on a ceiling tile if the ceiling tile is less that 18 mm
(0.71 inches) and is able to bear a weight of at least 5 kg (11.02 lb).
Do not mount the AP on a ceiling that is made of low-strength
Caution:
material such as plaster. If this installation method is required in such an
environment, you must put a high-strength plate beneath the ceiling to secure
the installation.
Installation
2
3
4
1
3: Mounting clip
4: Hook
Advertisement
