Husqvarna TC 250-450-510/2007 Workshop Manual page 358

SOSPENSIONE ANTERIORE (TE 250)
FRONT SUSPENSION (TE 250)
SUSPENSION AVANT (TE 250)
VORDERGABEL (TE 250)
SUSPENSIÓN DELANTERA (TE 250)
ADJUSTMENT
STANDARD setting for COMPRESSION: when in "completely closed" position,
12
unscrew by clicks (FIG.37)
STANDARD setting for REBOUND: when in "completely closed" position,
unscrew by 10 clicks (FIG. 38)
FIG. 37
Damping rate during COMPRESSION can be adjusted by turning the screw
adjuster (A), at the bottom of each leg, with a flat screwdriver. To reach the
adjuster, remove the protection plug (B) first. When adjusting, ALWAYS start
with the "completely closed" position, which can be reached by turning the
adjuster completely clockwise until it locks. Then, turn the screw counter
clockwise to the required position.
Each adjustment "clicks" in position.
IMPORTANT: Do not force the adjuster beyond the maximum closing and
opening position.
FIG. 38
Damping rate during REBOUND can be adjusted by turning the screw
adjuster (19) on the top of each leg with a small flat screwdriver. In order to
change the adjustment unit position, ALWAYS start with the "completely
closed" position, which can be reached by turning clockwise the adjuster until
it locks. Turn the adjuster counter clockwise until the wished position is
reached.
Each adjustment "clicks" in position.
IMPORTANT: Do not force the adjuster beyond the maximum closing and
opening position.
I.26
Part. N. 8000 A8796 (03-2007)