Panasonic U-26PE1U6 Technical Data & Service Manual page 192

CZ-RWST2U
7-17. Supplied Accessories
Wireless Remote Remote Control
Controller
(1)
7-18. Installing the Receiver
1 Open the air inlet grill on the side panel. Remove the 1 screw and move it toward the front
(in the direction of an arrow) to remove it. (Fig. 1-223)
2 Wrap the tip of a slotted screwdriver with plastic tape and then insert it under the O-marked
surface of the cover, wiggling the cover free. (Fig. 1-224) (Be careful not to scratch the panel.)
3 After passing the lead wire through the panel, install the receiver in the hole in the panel.
(The projecting parts of the receiver is held in the hole in the panel.)
1
4 Fasten the receiver's lead wire to the cable clip that is holding the wire from the louver motor.
(Fig. 1-225)
5 Attach the side panel.
6 Put the receiver's lead wire together with other wires such as the louver motor wire, and fasten
them with the cable clip. (Fig. 1-226)
Use the hole in the upper part of the wiring box to lead it in.
For more information about wiring and test runs, see the sections on "Wiringfor the Receiver" and
"Test Operation"
Panel
Fig. 1-223
Receiver
Supplied Accessories
AAA Size
Holder Battery Instructions
(1) (2)
Side panel
Air inlet grill
Cable clip
Fig. 1-225
Operating Wood Screw
(1) (2)
Plastic tape
Insert it under the
O-marked surface
of the cover.
1-184
1. Specifications
Clamper
(1)
Slotted screwdriver
(Wrapped with plastic tape)
Cover
Fig. 1-224
Cable clip
Panel
Fig. 1-226