Panasonic U-26PE1U6 Technical Data & Service Manual page 169

If you wish to change the selected indoor unit, follow the
step 2.
<Procedure of CZ-RTC4>
Stop the system before performing these steps.
1 Press and hold the ,
simultaneously for 4 seconds or longer.
2 If group control is in effect, press the
this time, the fan at the indoor unit begins and select the
address (unit No.) of the indoor unit operating.
3 Designate the item code "
Setting / buttons.
=91
4 Press the timer time
setting data.
Flap position
3
4
5
* Setting data "
Setting data Flap position during operation
Without separate setting
Swing
Move to position
Move to position
Move to position
Move to position
Move to position
and buttons
button to set. At
" by adjusting the Temperature
Electrical component box
=90
=93
=92
/ buttons to select the desired
1
2
Fig. 1-143
" (refer to Fig. 1-143)
1 and stay
and stay
2
and stay
3
4 and stay
and stay
5
When the flap position is set to
in the cooling or dry mode, the flap position is moved to
and the operation is started. (refer to Fig. 1-143)
3
NOTE
The flap swings during the operation under "Setting the
Flap Separately".
At this time, the unselected flaps are moved to the
position . (refer to Fig. 1-143)
1
5 Press the button.
(The display stops blinking and remains lit, and setting is
completed.)
If you wish to change the selected indoor unit, follow the
step 2.
6 Press the button to return to normal remote controller
display.
A
1-161
1. Specifications
or and the unit is
4 5
°
°
1