Motion Pedal Adjustment - Toro GreensPro 1200 Service Manual

Motion Pedal Adjustment

(Figures 14 and 15.)
1. Park machine on a clean, level surface with the
transport wheels in the raised and locked position.
Make sure engine is OFF. Remove spark plug wire
from spark plug.
1
Figure 14
2. Check motion pedal for correct adjustment by
placing a straightedge (1) across the top of motion
pedals (2). The straightedge should indicate that the
pedals are even with each other when correctly
adjusted.
3
Figure 15
3. If the straightedge determines that the pedals are
not even, adjustment of the linkage arm connected to
the transmission (3) is necessary.
4. To adjust linkage arm, remove transmission cover
from machine to gain access to transmission linkage
arm (see Transmission Cover in the Service and
Repairs section of this chapter).
GreensPro 1200
2
5
3
4
5
Page 5 - 11
NOTE: The linkage
approximately 7.09 in. (180 mm) between the centers
of the ball joints (4).
5. Loosen jam nuts (5) on linkage arm (3) and then
adjust linkage arm length until the motion pedals are
even with each other.
6. Tighten jam nuts (5) when linkage arm length is
correct.
7. Install transmission cover and secure with cap
screw (see Transmission Cover in the Service and
Repairs section of this chapter).
arm length should be
Chassis