Toro GreensPro 1200 Service Manual page 34

Disassembly
(Figures 8 and 9.)
2
3
1
5
Figure 8
1. Measure and record the distance from the end of
the pump collar (1) to the transmission housing before
removing the pump collar to ensure correct installation.
2. Loosen cap screw (2) and remove pump collar (1),
transmission fan (3), fan support ring (5), and key (4).
6
7
14
Figure 9
3. Remove straight fitting (6) and O-ring (7).
4. Remove straight fitting (13) and O-ring (14).
5. Remove lock nut (12), cap screw (10), two flat
washers (9), and spacer (8), and remove damper plate
(11).
Hydraulic System
4
10
9
8
11
9
12
13
Assembly
(Refer to Figures 8 and 9.)
1. Install damper plate (11), two flat washers (9),
spacer (8), cap screw (10), and lock nut (12).
2. Install straight fitting (13) and O-ring (14). Tighten
fitting to 26 lb-ft (35 N·m).
3. Install straight fitting (6) and O-ring (7). Tighten
fitting to 26 lb-ft (35 N·m).
4. Place transmission fan (3) and fan support ring (5)
over the transmission input shaft.
5. Install key (4) in transmission input shaft.
6. Install pump collar (1) on the transmission input
shaft, positioning it the same distance as noted during
removal. Tighten cap screw (2).
Installation
(Figures 10 through 15.)
6
1 2 3
1. Place transmission (6) on the roller chassis.
2. Apply anti-seize lubricant to transmission output
shaft.
3. Position 8-tooth sprockets (4) in the drive chain and
align the gears with the transmission output shaft.
Move the transmission toward the mounting bracket
while guiding the gears onto the shaft.
4. Secure the 8-tooth sprockets (4) to the transmission
output shaft using a retaining ring (5).
5. Secure the transmission to the bracket using three
cap screws (1), three lock nuts (2), and six flat washers
(3).
Page 4 - 10
1 2 3
5
1
4
Figure 10
GreensPro 1200
2 3