Oil Pressure Switch Inspection
1) Disconnect oil pressure switch (1) lead wire.
2) Check for continuity between oil pressure switch
terminal (2) and cylinder block (3) as shown.
If check result is not as specified, replace oil
pressure switch (1).
Oil pressure sensor specification
During engine running: No continuity
At engine stop: Continuity
4. Engine oil filter
Engine Coolant Temperature (ECT) Sensor
Inspection
Check engine coolant temperature sensor for resistance,
refer to "ECT Sensor Inspection in Section 1C".
S7RS0B9306007
I3RM0A930009-01
F: Front
S7RS0B9306008
Instrumentation / Driver Info. / Horn:
Brake Fluid Level Switch Inspection
Check for continuity between terminals of brake fluid
level switch coupler (1). If found defective, replace
switch.
Brake fluid level switch specification
OFF position (float up): No continuity
ON position (float down): Continuity
Parking Brake Switch Inspection
Check for continuity between parking brake switch
terminal and body ground as shown in figure. If found
defective, replace switch.
Parking brake switch specification
OFF position (parking brake released): No continuity
ON position (parking brake lever pulled up):
Continuity
1
1. Parking brake switch
9C-16
S7RS0B9306009
1
I4RS0B930007-01
S7RS0B9306010
2
I4RS0A930014-01
2. Parking brake lever