Controls And Functions; Front Panel - Yamaha SWP1-8 Owner's Manual

Controls and Functions

Front panel

The explanation here is based on the SWP1-16MMF.
1
1 LAN ports
These are etherCON (RJ-45) ports for connecting
Ethernet cables (CAT5e or better is recommended).
A cable with an RJ-45 connector can also be
connected.
All ports support 1000BASE-T, 100BASE-TX, and
10BASE-T.
2 MMF port
This is an opticalCON DUO port for connecting an
optical fiber cable. LC Duplex connectors can also
be connected.
If you use a cable with an LC Duplex connector,
fasten the dust cap attached to the cable connector
to prevent dust from adhering when the cable is not
in use. You can expand the MMF ports by installing
an optional MMF-SWP1 in the location where a cover
is attached. Installation of the MMF-SWP1 must be
performed by a Yamaha service engineer. Customers
must not attempt to perform the installation
themselves.
NOTE
• Use an opticalCON DUO multi-mode optical fiber cable
made by Neutrik Corporation. Since optical fiber cables
are vulnerable to being bent or pulled, you can reduce
the occurrence of problems by using a cable that has a
strong sheath and is equipped with a locking mechanism.
• Use GI-type multi-mode fiber cables that have a core
diameter of approximately 50 μm and cladding diameter
of approximately 125 μm. The maximum length between
devices is 300 m
Cleaning
Correct communication might not be possible if
debris and/or dust has adhered to the ends of optical
fiber cables or the ports. Clean the equipment
regularly by using commercially available optical
fiber cleaning products.
3 LED mode indicators
This indicates what the status indicators are showing.
4 [LED MODE] button
This switches what the status indicators are showing.
2 3 4
5 Status indicators
These indicate the status of each port. The displayed
content depends on the mode. For details on the
display in each mode, refer to "Status indicator
display."
6 DIP switches
These specify startup settings for the unit.
Set the DIP switches when the power is turned off.
The settings are not applied if you change the setting
while the power is on.
The switch illustrations indicate the up/down position
as follows.
Switch
position
• Switch 1 (CONFIG)
Specifies whether the unit's settings are optimized for
a Dante network or are set by the user.
Switch
position
1
1
5 6 7
Status
Represent a status with switch toggled up.
Represent a status with switch toggled
down.
Option Functions
The unit starts up with settings
DANTE
optimized for a Dante network.
The unit starts up with user
USER
settings.
SWP1 Owner's Manual
8
11