Siemens AT 18 Operating Instructions Manual page 15

The following settings can be made:
Function
Slow end open distance
Slow start open distance
Slow start close distance
Slow end close distance
Maximum speed open
Slow end speed open
Slow start speed open
Slow speed open initial
Maximum speed close
Slow start speed close
Slow end speed close
Slow speed close initial
Nudging speed
Acceleration ramp open
Deceleration ramp open
Reversal ramp open/close
Acceleration ramp open
Deceleration ramp close
Reversal ramp close/open
Idle torque open (current)
Idle torque close (current)
Peak torque close (current)
Limit force open
Limit force close
Limit force end close
Limit force nudging
Changes to the parameters should always be performed in normal operation with the
door in the "CLOSE" position since then the values are then taken over immediately by
the controller.
CAUTION
The maximum static closing force may not exceed 150N including the consideration of
the counterweights!
WARNING
The energies and forces are to be checked by the service
lift door and to be reduced to the limit values if necessary
NOTE
The acquired, optimal parameter settings can be recorded in the adjustment log (see
Appendix adjustment log). This log should also be available when addressing questions
to the Hotline.
15
Rev.01
Adjustment range Factory setting
0...100 mm 30 mm
0...100 mm 30 mm
0...100 mm 20 mm
0...100 mm 40 mm
100...800 mm/s 700 mm/s
30...90 mm/s 40 mm/s
30...90 mm/s 60 mm/s
30...90 mm/s 90 mm/s
100...500 mm/s 319 mm/s
30...90 mm/s 60 mm/s
30...90 mm/s 40 mm/s
30...90 mm/s 90 mm/s
50...250 mm/s 150 mm/s
300...1400 mm/s² 1300 mm/s²
300...1400 mm/s² 600 mm/s²
300...1400 mm/s² 1200 mm/s²
300...1400 mm/s² 500 mm/s²
300...1400 mm/s² 500 mm/s²
300...1400 mm/s² 850 mm/s²
0...3,5A 0,7 A
0...2,5A 0,7 A
0...10,0A 3,0 A
70...300 N 300 N
70...230 N 90 N
70...230 N 90 N
70...230 N 90 N
.
Operating instructions AT18 SEDM
Issue 09/05
staff after start-up on the heaviest