Brother PR600II Service Manual page 255

Test mode
11. Error list
The latest error is displayed.
[<] [>] : Changes the language.
[+] : Opens the error message that is the old by one.
[-] : Opens the error message that is the now by one.
[CLOSE] : Closes the <ERROR LIST> screen.
12. Default setting
Select this mode to initialize the panel settings.
Items to be initialized are listed below.
[Editing information]
Parameters
Thread spool
Reserved thread
Sewing area display
Grid display
Cursor display
Sewing order display
Display expanded thread color OFF
Thread selection
DST thread trimming feed
Deleting short stitches
Remaining length of thread
Units of measurements
Custom thread table 1, 2
Starting / Ending position
Lock stitch
Maximum speed
[System setup data]
• Language (reset to the factory-set language.)
• Resumption (operation is not resumed even when suspension is released. Number of switches is returned to
[0].)
• Buzzer: [Beep] is set.
[Empty pocket]
Empties the pocket data.
Default
All color information set for spools is cleared, resulting
in no spool set.
All spools are released.
LL frame area is displayed.
Only the center is displayed.
A small cross cursor is displayed.
Name of Color
Brother's original pallet
+3 when thread trimming is turned on
0.3 mm or less
Standard
mm
All registered custom settings are reset.
Center (both start and end of sewing)
ON
Tubular frame: 600 rpm
Cap frame: 400 rpm
4 - 15