Hitachi AMS 2100 Getting Started Manual page 35

Confirming your selections
1. Review your selections in the next five confirmation pages:
a. If no changes are required, click Next.
b. If you need to change a selection, click Back to return to the
appropriate page, make the desired changes, and then click Next to
return the first confirmation page and verify that the change was
made.
c. At the last confirmation page, click Confirm to commit your
selections.
2. When the finish page appears, click Finish.
3. When the next page tells you that the initial setup of the storage system
was completed successfully, click Finish.
Change controller IP addresses
1. If the storage unit was not added to your storage network:
a. Log out of Navigator 2.
b. Power-off the storage unit.
c. Add the storage unit to the network.
d. Reconnect the management console to the management ports.
e. Restart your browser and log in to Navigator 2 again.
NOTE: Configure the console for the same subnet on which the base unit
is installed. Otherwise, an error message appears when you try to access
Navigator 2.
Figure 1-25: Set Up Date & Time Page
Hitachi AMS 2100/2300 Getting Started Guide
33