Hitachi AMS 2100 Getting Started Manual page 31

Table 1-5: Configuring Management Ports (Continued)
If You Selected the IPv6 Protocol in the Set Up Management Ports Page:
IPv6 Address
Subnet Prefix Length
IPv6 Default Gateway
Negotiation
If your:
• Management console is directly connected to a management port on one controller,
enter settings only for that controller (you will configure the management port
settings for the other controller later).
• Management console is connected using a switch or hub, you can enter settings for
both controllers now.
Set up host ports
The next part of the wizard lets you configure the Fibre Channel and iSCSI
ports on your storage system. These settings are configured on separate
pages within the wizard. The first page that appears lets you configure the
Fibre Channel ports.
1. In the first Set up Host Ports page, enter configuration information for
each Fibre Channel port that will be used.
Field
Static Internet Protocol address that client PCs use to access
the base unit's management port.
Subnet prefix length that client PCs use to access the base
unit's management port.
Default gateway that client PCs use to access the base unit's
management port.
Use the default (Auto) setting to auto-negotiate speed and
duplex mode, or select a fixed speed and duplex setting.
Hitachi AMS 2100/2300 Getting Started Guide
Description
29