Hitachi BD-W3500 Operating Instructions Manual page 9

(door lock) Lights or blinks when the door is locked.
HIGH (temperature) Lights or blinks when the inside of the drum is hot.
DRY FILTER Blinks when the dry filter is clogged or after every 25 times the [WASH DRY] and [DRY] operations are used.
LINT FILTER Blinks when the lint filter is not attached properly or clogged, or after every 30 times the [WASH]
and [WASH DRY] operations are used.
WIND IRON Lights when a program that uses the Wind Iron function is selected. Blinks during Wind Iron
operation.
Adjust the level of drying (P. 66)
Adjust the level of drying to one of three
levels: [EXTRA], [REGULAR], or [MILD].
The factory default setting is [REGULAR].
Buttons that function differently when held for 3 to 5 seconds after turning on the power
Turn the Tangle-Free Finish function
on or off.
Change the operation start/finish
sound.
Turn the Soft Guard function on or
off.
Status indicators (P. 31, 32, 71 to 74)
Cycle through (i.e., light) the selectable programs
for each operation by pressing the [WASH], [WASH
DRY], [DRY], or [CLEAN] button.
Turn the power on or off.
START/PAUSE button (P. 31, 32)
Start or pause an operation.
Even if you press [PAUSE] during a drying
operation, you cannot open the door until the inside
of the drum has cooled.
Make sure that the door is closed before
pressing the button. Failure to do so may result in
malfunction of the machine.
(P. 69) Turn the pre-finish sound on or off.
Turn the temperature sensor control on
or off.
(P. 64) Adjust the spin speed during [WASH
DRY] operations.
Adjust the spin startup conditions.
Change the dehumidification mode (Air /
(P. 69)
Water Cooling).
Select a program (P. 34 to 55)
The selectable programs differ for each operation.
Power buttons (P. 79)
If you turn the power on and do not start an operation
within 10 minutes, the power will turn off automatically
(Auto Power Off).
The power turns off automatically after an operation
finishes.
(P. 64)
(P. 67,
68)
(P. 70)
9