Table of Contents
Advertisement
Symptom
Is the
When the inside of the drum is hot due to
drying operations and warm-air spinning,
a cooling operation is used to cool the
temperature down.
Is the DOOR LOCK set?
The DOOR LOCK will remain set and the
door will remain locked even when the power
automatically turns off after an operation
finishes.
The door does not
open.
Is there water inside the drum?
Depending on the water level during the
operation, the door lock may not release.
Is air blowing?
Even if you pause the operation, the door will
not open until the airflow stops.
Is "000" blinking in the remaining time
indicator?
If so, Soft Guard operation is in progress.
Is there an obstruction stuck between the door
lock area?
The door does not
close.
Is the door stopper extended?
The drum and
drain hose are wet,
Moisture and condensation from function tests
even though they
performed at the factory may still remain in the
have never been
drum and drain hose.
used.
The color of the
Contact with water and detergent can oxidize
drum has changed.
and discolor the drum.
The power does
Is the power plug connected to a power outlet?
not turn on.
Did a power outage occur? Did a fuse blow or a
short circuit occur?
Is there an appliance that emits noise, such as
a television or radio, near the machine?
If noise continuously enters the machine, the
The operation
power will turn off.
stops or the power
turns off while in
If the temperature of the drum rotation
progress.
motor reaches a certain level, the power is
automatically turned off for safety.
If you start a drying operation while the dry
filter is clogged, the power may turn off
automatically.
The display
does not appear
The machine will beep twice when you press
immediately after
the [ON] button, and the display will light about
turning on the
1 second later.
power.
Possible cause
indicator blinking?
HIGH
Solution
Wait until the inside of the drum cools down. You
can open the door when
HIGH
Release the DOOR LOCK.
(P. 33)
Run a spin operation to drain the water.
Wait until the airflow stops.
Press the [PAUSE] button to unlock the door. For
details on the Soft Guard setting, see (P. 69).
Remove any objects.
Press the right middle area of the door, and close
it completely.
Return the door stopper to its original position.
(P. 33)
This is not a malfunction.
If this is a concern, wipe the drum using a
stainless steel detergent.
Connect the power plug to a power outlet.
Press the [ON] button, and restart the operation.
Disconnect the power plug and reconnect it,
and then press the [ON] button and restart the
operation. Do not place televisions and radios
near the machine.
This is not a malfunction.
Wait about 1 hour before restarting the operation.
This is not a malfunction.
Clean the dry filter.
(P. 73, 74)
This is not a malfunction.
The control board takes a few moments to
startup.
turns off.
(P. 32)
85
Hide quick links:
Advertisement
Table of Contents
