Restoring The Axs Memory Card; Using A Usb Wireless Lan Module; Attaching The Ifu-Wlm3 - Sony PMW-F55 Operating Instructions Manual

Restoring the AXS Memory Card

If a data error occurs on the AXS memory card for
some reason, the card must be restored.
If an AXS memory card that needs to be restored
is connected, a message prompting you to execute
restoration is displayed on the LCD monitor/
viewfinder screen.
Restore the card as instructed follows.
Select "Execute" by turning the MENU
dial, then press the MENU dial.
During restoration, the in-progress message and
status bar are displayed, and the ACCESS lamp
lights in red.
When restoration is completed, the completion
message is displayed, then press the MENU dial
to disappear the message.
If restoration fails
• A write-protected AXS memory card or one on
which an error occurred cannot be restored. For
such a card, a warning message is displayed.
Release the write protection or replace the card,
according to the instructions in the message.
• An AXS memory card on which an error
occurred may become usable again through
repeated formatting.
• In some cases, only parts of clips cannot be
restored. Playback of the restored clips becomes
possible again.
Note
For restoration of media recorded with this unit, be sure
to use this unit. Media recorded with a device other than
this unit or with another unit of different version (even of
the same model) may not be restored using this unit.
30

Using a USB Wireless LAN Module

Using a USB Wireless
LAN Module
You can make the Wi-Fi connection between the
camcorder and a device such as a smartphone,
tablet, etc., by attaching the supplied IFU-WLM3
USB wireless LAN module.
Note
You cannot use a USB wireless LAN module other than
the IFU-WLM3.
Making a Wi-Fi connection between a device and
the camcorder enables you to do the following.
• Operate the setup menu (displayed on the LCD
monitor/viewfinder screen)
• Record and playback the camcorder
• Display the current status of the camcorder
• Switch between the recording settings and
system settings
• Operate the assignable buttons of the camcorder

Attaching the IFU-WLM3

1
Open the cover of the USB wireless
LAN module retracting part (page 11).
2
Insert the IFU-WLM3 to the USB
connector.
3
Close the cover.